Thermodynamic Evaluation for Intermediate Temperature Optimization in Low Temperature Heat Source Cascade Heat Pump Technology

Authors

  • Ali Hussain Tarrad University of Southern Denmark

Keywords:

Cascade Heat Pump, Intermediate Temperature, Green Environment, Sustainable Energy, Optimum COP

Abstract

A thermodynamic analysis assessment for the intermediate temperature in the cascade heat exchanger of a Cascade system is outlined. R407C/R134a and R410A/R134a pairs are studied at low evaporating temperature range between (-10 and -2) °C and (70) °C and (75) °C high temperature condenser levels. Low temperature heat sources are considered as the external driving potential sources and brines as thermal fluid carriers of energy. The analysis was based on a target temperature of hot water at the range of (60-70) °C out of the heat pump. Cascade heat exchanger intermediate temperature range of (28.5 to 39) °C was studied. The high extreme intermediate temperature exhibited the best heating COP for both refrigerant systems regardless of LT evaporator or HT condenser temperatures. The minimum isentropic efficiency of commercially available compressors was used in this investigation, a value of (70 %) was chosen. R407C/R134a system achieved only (1 %) higher COP than that of R410A/R134a for the whole test range of intermediate, LT evaporator, and HT condenser temperatures. The results showed that the heat pump heating COP at LT evaporator of (-7) °C and HT condenser temperature of (70) °C showed similar characteristic values to that of LT evaporator (-2) and HT condenser of (75) °C for intermediate temperature range between (31-39) °C. The highest COP was achieved at (-2) LT evaporator temperature and (70) °C HT condenser temperature. It was ranged between (2.2) and (2.8) for the whole test range of intermediated temperature. The lowest heating COP was experienced when the LT cycle refrigerant evaporates at (-10) °C and the HT cycle refrigerant condenses at (75) °C for both refrigerant pair systems. It was ranged between (1.95) and (2.4) at (28.5 to 39) °C intermediate temperature. Increasing of compressors isentropic efficiency to (90 %) has improved the heating COP of both refrigerant systems potentially by more than (20 %) and minimized the power consumption by (24 %) under the same operating conditions. 

Author Biography

Ali Hussain Tarrad, University of Southern Denmark

PhD Mechanical Engineering

Mechatronic Department

References

• Kim, J., Lee, J. Choi, H, Lee S., Oh, S. and Park, W., (2015), Experimental study of R134a/R410A Cascade cycle for variable refrigerant flow heat pump systems, Journal of Mechanical Science and Technology, 29 (12), pp 5447-5458, DOI: 10.1007/s12206-015-1146-2.

• Mahler, A., Røgen, B., Ditlefsen, C., Nielsen, L. H., and Pedersen, T. (3-7 June 2013), Geothermal energy use, Country update for Denmark; European Geothermal Congress, Pisa, Italy.

• Nanxi, L., Shi, L., Lizhong, H., and Mingshan, Z., (2005), Moderately high temperature water source heat-pumps using a near-azeotropic refrigerant mixture, Applied Energy, 80, pp 435–447.

• Parka K., Jung D., (2009), Performance of heat pumps charged with R170/R290 mixture, Applied Energy, 86 (12), pp 2598–2603.

• Song, Y., Li, D., Yang, D., Jin, L., Cao, F., and Wang, X., (2016), Performance comparison between the combined R134a/CO2 heat pump and Cascade R134a/CO2 heat pump for space heating, International Journal of Refrigeration, DOI:10.1016/j.ijrefrig. 2016.12.001.

• Tarrad, A. H., (2017, “aâ€), Thermodynamic analysis for hybrid Low temperature sustainable energy sources in Cascade heat pump technology, Asian Journal of Engineering and Technology (AJET), 5 (2), pp 29-46.

• Tarrad, A. H., (2017, “bâ€), Thermodynamic performance evaluation for low temperature heat source Cascade system circulating environment friendly refrigerants, International Journal of Energy and Environmental Science, 2 (2), pp 36-47, DOI: 10.11648/j.ijees.20170202.12

• Tarrad, A. H., and Abbas, A. K., (2010), Evolution of a proper alternative refrigerant for R-22 in air conditioning systems, Emirates Journal for Engineering Research, 15 (2), pp 41-51.

• Tarrad, A. H., and Al-Nadawi A. K., (2015), Modeling of finned-tube evaporator using pure and zeotropic blend refrigerants, Athens Journal of Technology & Engineering, 2 (4), pp 263-281.

• Tarrad, A. H., and Al-Nadawi, A. K., (2016), A rating model for air cooled condensers using pure and blend refrigerants, American Association for Science and Technology (AASCIT), American Journal for Science and Technology, 3 (1), pp 1-11.

• Tarrad, A. H., Altameemi, A. F., and Mahmood, D. M., (2016), A numerical rating model for thermal design of air cooled condensers in the industrial applications, American Association for Science and Technology (AASCIT), American Journal of Mathematical and Computational Sciences, 1 (1), pp 18-28.

• Tarrad, A. H. and Salim, A. Y., (2009), Experimental perspective assessments for a proper refrigerant alternative to R-22 in a window type air conditioning unit", Journal of Engineering, 15 (2), pp 3756-3775.

• Tarrad, A. H., Saleh, F. A., and Mahmood, D. M., (2011), A proper alternative refrigerant for R-22 in water chillers, Gulf University Journal, 3 (1), Eng. Div., pp 161-179.

• Tarrad, A. H., Saleh, F. A., and Mahmood, D. M., (2013), A quasi-steady state operation mode of alternative refrigerants for R-22 in water chillers, The Iraqi Journal for Mechanical and Material Engineering, 13 (1), pp 13-33.

• Technical University of Denmark (DTU), (2001), “CoolPack Software: A Collection of Simulation Tools for Refrigerationâ€, Denmark.

• Yrjölä, J. and Laaksonen, E., (2015), Domestic hot water production with ground source heat pump in apartment buildings, Energies, 8 (8), pp 8447-8466, DOI:10.3390/en8088447.

• Zhang, S., Wang, H., and Guo, T., (2010), Experimental investigation of moderately high temperature water source heat pump with non-azeotropic refrigerant mixtures, Applied Energy, 87 (5), pp 1554–1561.

Downloads

Published

2017-10-30

How to Cite

Tarrad, A. H. (2017). Thermodynamic Evaluation for Intermediate Temperature Optimization in Low Temperature Heat Source Cascade Heat Pump Technology. Asian Journal of Engineering and Technology, 5(5). Retrieved from https://ajouronline.com/index.php/AJET/article/view/5032